 |
 |
 |
 |
 |
WL 204 Marcet Boiler Measurement of pressure and temperature
|
 |
WL 102 Change of State of Gases Isothermic and isochoric change of state of air
|
 |
TM 605 Coriolis Force Demonstrator Apparent forces in a rotating reference system
|
 |
WL 202 Fundamentals of Temperature Measurement Experimental introduction to temperature measurement (eight different temperature measurement methods): methods, areas of application, characteristics
|
 |
WL 203 Methods of Pressure Measurement Measurement of pressure above and below atmosphere
|
 |
HM 150.02 Dead-Weight Piston Gauge under construction!
|
 |
HM 150.18 Osborne Reynolds Experiment Visualisation of laminar and turbulent flow
|
 |
HM 115 Hydrostatics Trainer A well equipped hydrostatics bench allowing numerous experiments on the topic of hydrostatics of liquid and gases
|
 |
HM 150.05 Hydrostatic Pressure Apparatus under construction!
|
 |
HM 150.06 Stability of Floating Bodies Determining metacentre and buoyancy using a rectangular hull cross-section
|
 |
HM 150.39 Floating Bodies for HM 150.06 Stability of hulls with different forms
|
 |
HM 150.07 Bernoulli's Principle Static pressure and total pressure distribution along the venturi nozzle
|
 |
HM 150.08 Measurement of Jet Forces Demonstration of the principle of linear momentum and impact forces on interchangeable deflectors with different deflection angles
|
 |
HM 150.09 Horizontal Flow from a Tank Demonstration of Torricelli's theorem in visual form
|
 |
HM 150.12 Vertical Flow from a Tank Determination of flow rate coefficients and flow rate for various water heads and experiments on discharge jets
|
 |
HM 150.14 Investigation of Vortex Formation under construction!
|
 |
HM 150.01 Pipe Friction for Laminar / Turbulent Flow Determining the critical Reynolds number
|
 |
HM 150.29 Losses in Bends and Fittings under construction!
|
 |
HM 150.11 Losses in Piping Elements, Valves and Fittings Investigating the influence of flow rate and cross-sectional profiles on pressure loss in pipes and fittings
|
 |
HM 150.13 Methods of Flow Measurement under construction!
|
 |
HM 150.03 Flow Over Weirs Accessory under construction!
|
 |
HM 241 Principles of Hydraulics under construction!
|
 |
HM 150.21
Visualization of Streamlines in an Open Channel Demonstrating flow and flow around various drag bodies and weirs using ink as contrast medium
|
 |
HM 164 Open Channel and Closed Channel Flow Flow processes on different structures in open and closed channel flows
|
 |
HM 150.10
Visualization of Streamlines Investigation of flow around models in laminar, two-dimensional flow using ink as contrast medium
|
 |
HM 135 Drag Coefficients for Spheres under construction!
|
 |
HM 150.19  Operating Principle of a Pelton Turbine Model of a free jet turbine with adjustable nozzle and determination of the efficiency
|
 |
HM 150.20  Operating Principle of a Francis Turbine Model of a reaction turbine with adjustable guide vanes and determination of the efficiency
|
 |
HM 150.04 Centrifugal Pump Determining the characteristics of a typical centrifugal pump
|
 |
HM 150.16 Series and Parallel Connected Pumps Determining the characteristic curves and hydraulic power output and comparison of series and parallel operating modes
|
 |
HM 150 Base Module for Experiments in Fluid Mechanics Volumetric flow measurement for large and small flow rates
|
|