Home           Products           Company           Contact us     
> Fundamentals of Control Engineering
> Components and Calibration
> Simple Process Engineering Control Systems
> Complex Process Engineering Control Systems
> Fundamentals of Process Engineering
> Mechanical Process Engineering
> Thermal Process Engineering
> Chemical Process Engineering
> Biological Process Engineering
> Water Treatment
Products  |  Process Engineering  |  Fundamentals of Process Engineering  |  CE 105
CE 105 Corrosion Studies Unit Show data sheet (pdf file) Print page
Technical Description

  Corrosion damage to metallic components causes considerable economic and technical damages. The issue of corrosion and corrosion protection therefore plays an important role in technical training.
  The CE 105 allows a variety of factors that influence corrosion processes to be investigated in parallel. Eight glass vessels are available to do this. They allow different materials to be compared under different conditions. The required electrolyte solution is added to the vessels. Up to 6 specimens can be attached to the cover of each vessel and these are immersed in the solution. It is possible to connect specimens to an electrical conductor to investigate local elements and the principle of sacrificial anodes. An adjustable power pack allows an external voltage to be connected. This counters the current flow between precious and base metals in local elements. As result the corrosion rate of the more base metal is reduced.
  A diaphragm pump conveys ambient air into the electrolyte solution as required. Flow control valves can be used to individually adjust the gas flow rate for each vessel. It is also possible to feed other gases provided by the laboratory into the electrolyte solution. A pH meter is included to allow the influence of the electrolyte solution on corrosion processes to be investigated and compared.

  The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.


Learning Objectives / Experiments

- corrosion behaviour of different metallic materials

  (rust / passivation)
- formation of local elements
- influence of pH value of the electrolyte solution
- influence of salt concentration in the 
  electrolyte solution
- oxygen corrosion
Corrosion protection
- external voltage
- sacrificial anodes
- protective layers


* Principles of corrosion and corrosion protection on

  metallic materials1
* Oxygen corrosion1
* Electrochemical corrosion (local elements)1
* Corrosion protection with external voltage and

  sacrificial anodes


[1] investigation of corrosion and corrosion protection measures
[2] 8 electrolyte vessels with covers and 6 specimen holders each
[3] adjustable power pack for application of external voltage
[4] air supply via diaphragm pump
[5] reversing valve for air or external gas supply
[6] adjustment of gas flow rate for each vessel using flow control valves
[7] recording of pH value of electrolyte solutions using manual unit
[8] pressure range for external gas supply: 0,2...1,0bar


Technical Data

Electrolyte vessels
- capacity: 1.000mL
- material: glass
Power pack
- voltage: 0...30VDC
- current: 05A
Diaphragm pump: approx. 260L/h
pH meter
- measuring range: 014pH
- resolution: 0,01pH
- 6x stainless steel, steel, copper, brass, aluminium

- 3x glass
- dimensions: 100x15x1mm


Dimensions and Weight

LxWxH: 1.280x460x630mm (experimental unit)
Weight: approx. 55kg

LxWxH: 730x480x240mm (storage system)
Weight: approx. 15kg

Required for Operation
230V, 50/60Hz, 1 phase; 120V, 60Hz/CSA, 1 phase
Scope of Delivery

1 corrosion experimental unit
1 pH meter
1 set of specimens

1 set of laboratory cables

1 coupling to connect an external gas supply

1 storage system

1 set of instructional material

Order Details
083.10500  CE 105  Corrosion Studies Unit
© 2005 G.U.N.T. Gerätebau GmbH