Convection dryers are often used for drying solids in food technology. The CE 130 can be used to investigate and demonstrate the process of convection drying of granular solids.

  Four corrosion resistant removable plates are available for drying the solid. They are put in a drying channel. The plates containing the solid to be dried are exposed to an airflow in the channel. The airflow heats the solid and also removes the quantity of humidty that is released. Air velocity can be adjusted by the speed of a fan. An adjustable heater allows the heating of the air. The transparent door in the drying channel allows the drying process to be observed. A digital balance can be used to follow the changes in weight of the solid due to evaporation or vaporisation of quantity of humidity during operation. The air temperature and the relative humidity of the air are measured and digitally displayed by a single combined temperature and humidity sensor before and after the airflow passes over the solid. A further sensor measures the air velocity.

  The relevant measured parameters (changes in weight, humidity, temperature, air velocity) can be transferred directly to a PC, where they can then be further processed.

  The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.

- influence of air temperature and humidity on drying

  intensity
- plotting of drying curves with constant external

  conditions
- determination of drying rate with different air

  parameters and different solid properties
- evaluation of drying processes using energy and

  mass balances