Home           Products           Company           Contact us     
> Engineering Drawing
> Cutaway Models
> Dimensional Metrology
> Fasteners and Machine Parts
> Manufacturing Engineering
> Assembly Projects
> Maintenance
> Machinery Diagnosis
> Automation
Products  |  Mechatronics  |  Machinery Diagnosis  |  PT 500.16
PT 500.16 Crank Mechanism Kit Show data sheet (pdf file) Print page
Technical Description

  Crank drives are frequently used in compressors and pumps. They cause vibration due to the oscillating masses and forces. Under the alternating stress in the drive mechanism, bearing clearance, for example, can generate shock impacts with high-frequency exciter spectra. In addition, free mass forces generate harmonic vibrations due to their non-linear kinematics.  
  The PT 500.16 accessory set enables the stroke, mass balance and bearing clearance on the crosshead to be adjusted. The speed is adjusted using the base unit PT 500. Gas pressure forces such as occur in compressors or combustion engines can be simulated using springs. Experiments with gas pressure forces require higher torques which are attained by reducing the speed of the drive motor from the base unit PT 500. This reduction is achieved either with the PT 500.14 belt drive or the PT 500.15 gear unit.

  The transmission of alternating torque in toothed gearing mechanisms can be investigated together with accessory set PT 500.15 (for investigating damage to gears). 
  The accessory set is mounted on the base plate of the machinery diagnostic base system PT 500.

  To measure and evaluate the experiment, the computerised vibration analyser PT 500.04 is required. It includes all the necessary sensors, a measurement amplifier and analysis software to record the vibration phenomena.

Learning Objectives / Experiments

- experimental modal analysis of mechanical


- influence of bearing clearance and shock impact
- inconsistent torque characteristic
- wear measurement on piston rods

- understanding and interpreting frequency spectra
- use of a computerised vibration analyser
in conjunction with PT 500.15
- transmission of alternating torque in toothed

  gearing mechanisms
in conjunction with PT 500.14 or PT 500.15
- influence of gas pressure forces on the vibration



* Vibrations of crank drives1
* Bearing clearance or slack in oscillating machine


Available accessories
PT 500 -- Machinery Diagnostic System, Base Unit
PT 500.04 -- Computerised Vibration Analyser
PT 500.14 -- Belt Drive Kit
PT 500.15 -- Damage to Gears Kit
Alternative products
TM 180 -- Balance of Reciprocating Masses

[1] investigation of the vibrations of crank drives
[2] crank drive with adjustable stroke
[3] interchangeable bearing bushes permit simulation of bearing clearance
[4] springs simulate gas pressure forces
[5] can be used together with gear damage accessory set PT 500.15
[6] belt drive PT 500.14 or gear unit PT 500.15 required for experiment with gas pressure forces
[7] accessory set for PT 500 machinery diagnostic training system
[8] stackable box for all components


Technical Data

Stroke: 50 - 75 - 100mm
Balance mass total

- 490g, rated for operation with 50mm stroke
Bearing clearance: 0...1mm
Pressure spring
- relaxed length: 170mm
- spring stiffness: R=0,55N/mm


Dimensions and Weight

LxWxH: 600x400x170mm (box)
Weight: approx. 8kg

Scope of Delivery
1 crank drive
2 springs
2 balance masses
1 set of tools
1 storage box with foam inlay
1 manual
Order Details
052.50016  PT 500.16  Crank Mechanism Kit
© 2005 G.U.N.T. Gerätebau GmbH