Home           Products           Company           Contact us     
> Engineering Drawing
> Cutaway Models
> Dimensional Metrology
> Fasteners and Machine Parts
> Manufacturing Engineering
> Assembly Projects
> Maintenance
> Machinery Diagnosis
> Automation
Products  |  Mechatronics  |  Machinery Diagnosis  |  PT 500.14
PT 500.14 Belt Drive Kit Show data sheet (pdf file) Print page
Technical Description

  When properly designed, manufactured, and correctly set; belt drives are low-maintenance, low-noise, long-life drive units. It is important that the belt should not vibrate and/or slip.
  The PT 500.14 accessory set-up can be used to investigate conditions that cause vibration or slip. The effect of disparate elongation on multiple belt drives can be demonstrated by means of individually-adjustable tensioning rollers. The belt drive is a dual belt drive with a belt tensioner. It can, however, also be operated with only one belt.  An eccentrically-bored small belt pulley and a damaged V-belt enhance the range of possible experiments.
 
  The brake and PT 500.05 load unit is required to conduct the experiment. The accessory set PT 500.14 can also be used to apply transverse loads in other experiments.
 
  The accessory set is mounted on the base plate of the machinery diagnostic base system PT 500.
  To measure and evaluate the experiment, the computerised vibration analyser PT 500.04 is required. It includes all the necessary sensors, a measurement amplifier and analysis software to record the vibration phenomena.

 
Learning Objectives / Experiments

- Influence of belt tension on vibration behaviour
- Influence of speed on vibration behaviour
- Influence of pulleys running untrue, and off-track

  running
- Power split across multiple belt drive
- Influence of slip on vibration running spectrum
- Comparison between fault-free and damaged belts

- Understanding and interpreting frequency spectra
- Use of a computerised vibration analyser

Features
* Vibrations in belt drives1
* Resonance and critical speed
Available accessories
PT 500 -- Machinery Diagnostic System, Base Unit
PT 500.04 -- Computerised Vibration Analyser
PT 500.05 -- Brake & Load Unit
Specification

[1] Investigation of the vibrations of belt drives
[2] Dual belt drive with V-belt
[3] Belt drive can be operated with one belt
[4] Individually-adjustable tensioning rollers
[5] Belt drive with eccentricity
[6] Damaged V-belt
[7] Belt pre-tension measuring device 0...150N
[8] Suitable for applying transverse loads on other systems within the accessory sets of the PT 500 series
[9] Brake and load unit PT 500.05 required for experiments on the belt drive
[10] Accessory set for PT 500 machinery diagnostic training system
[11] Stackable box for all components

 

Technical Data

V-belt pulleys
- large: D=125mm
- small: D=63mm
- small, eccentric: D=63mm
 
Axle centres: 300mm
V-belt
- SPZ, approx. 10mm wide
- belt length: 912mm

 

Dimensions and Weight
l x w x h: 600x400x170mm (box)
Weight: approx. 6kg
Scope of Delivery
3 V-belts
3 belt pulleys
1 tensioning roller set
1 belt pre-tension measuring device
1 storage box with foam inlay
1 manual
Order Details
052.50014  PT 500.14  Belt Drive Kit
Print
© 2005 G.U.N.T. Gerätebau GmbH