Home           Products           Company           Contact us     
> Fundamentals of Thermodynamics
> Applied Thermodynamics
> Renewable Energies
> Power Engines and Machines
> Internal Combustion Engines
> Refrigeration and Air Conditioning Technology
> Heating and Ventilation in Buildings
> Sanitary Systems
Products  |  Thermal Engineering and HVAC  |  Internal Combustion Engines  |  CT 400  |  CT 400.01
CT 400.01 4-Cylinder Petrol Engine Show data sheet (pdf file) Print page
Technical Description

In conjunction with the CT 400 load unit, the CT 400.01 engine is a complete engine test stand. The engine used here is a four-cylinder petrol engine with a controlled catalytic converter. It has its own closed cooling water circuit.
  A solid welded frame on rollers, with a vibration-insulated base plate, carries the entire set-up. Hazardous areas such as hot surfaces and rotating parts are covered with perforated plates. The connection to the brake is made via a rotationally elastic coupling with a jointed shaft. The engine is attached to the load unit by fasteners.
  The engine is fitted with sensors that measure the temperatures and the cooling water flow rate. The switch cabinet contains all of the electronic equipment for managing the engine (factory set). On the switch cabinet are an ignition key, an operating time counter and warning lamps. Data is transferred between the CT 400 load unit and the engine via a data cable connecting the switch cabinets for the two units. A starter battery is also housed in the frame.
  For safety reasons, the engine has been modified in a way that it only starts when it is connected to the load unit both mechanically and electrically.

  The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.


Learning Objectives / Experiments

In conjunction with CT 400 load unit
- Plotting of torque and power curves
- Determination of specific fuel consumption
- Determination of volumetric efficiency and lambda

  (fuel-air ratio)
- Energy balances
  * overall engine efficiency

* Engine for set-up of a test stand in conjunction with
  the CT 400 load unit1
* Closed cooling water circuit1
* Easy connection to the CT 400 load unit
Alternative products
CT 400.02 -- 4-Cylinder Diesel Engine
[1] Water-cooled four-cylinder petrol engine for set-up of a test stand in conjunction with the CT 400 load unit
[2] Engine flexibly mounted on mobile frame with vibration-insulated base plate
[3] Force transmission to brake via rotationally elastic coupling and jointed shaft
[4] Engine complete with fuel supply (tank, pump, hose) and cooling water circuit
[5] Sensors for cooling water flow rate and temperatures (exhaust gas, cooling water, fuel, oil)
[6] Transfer of measured data via data cable from switch cabinet to CT 400 switch cabinet
[7] Switch cabinet with warning lamps (oil pressure, alternator failure), operating time counter and ignition key
Technical Data

Water-cooled four-cylinder petrol engine
- displacement: 1388cm³
- bore: 76mm
- stroke: 76.5mm
- power output: max. 55kW at 5700rpm
- torque: max. 124Nm at 3500rpm
- compression ratio: 11:1

- ignition sequence: 1-3-4-2
Starter battery: 12V

Fuel tank capacity: 5L
Fuel: petrol 95 Octane
Engine oil: SAE 5W-30

Dimensions and Weight
l x w x h: 1250 x 1150 x 1400 mm
Weight: approx. 250 kg
Required for Operation
230V, 50/60Hz, 1 phase or 230V, 60Hz, 3 phase
Scope of Delivery
1 engine, built into frame
1 set of instructional material
Order Details
063.40001  CT 400.01  4-Cylinder Petrol Engine
© 2005 G.U.N.T. Gerätebau GmbH